Mini Servo Section Board Power Box for Gas Plane with Kill Switch

Technology Parameters:

²  Working Voltage:   5V-8.4V

²  Current:  0A-30A

²  Weight:   70g

²  Size:  116mm (L)*88mm (W)*13mm (H)

²  Working Temperature:  -20℃ to 85℃.

CDI Power Supply Indication：

²  Green Light Continue Lighting： voltage above 4.8V

²  Green Light Flashing： 4.5-4.8V

²  Red Light Continue Lighting： 4.2-4.5V

²  Red Light Flashing： voltage below 4.2V

Function Introduction (picture please see the above attached)：

A----1-8 Channel

B---- Receiver Power Supply Port

C----1-8 Channel Output Port

D---- CDI Control Channel For “OFF” /Switch Channel for Radio

E---- Sponge Bumper, Installation Place for Receiver

F---- Magic Sticker for Receiver

G---- Indication Light For CDI Power Status

H---- Output Port for CDI Power

I---- Input Port for CDI Power

J---- Indication light for CDI Voltage

K---- Power Switch for Section Board

L---- Input Port for Battery 1

M---- Input Port for Battery 1

Produce Features:

²  Eight channels for input and sixteen channels for output (Every one channel input with two channels output)

²  Integrates CDI remote flameout switches through each channel of the remote controller or switch channel (usually choose a switch channel) can make the gasoline engine’s CDI on or off by remote control.

²  Independent CDI power supply socket. Receiver power completely separates with the CDI power, so you should not worry about that CDI arouses high frequency signal will interfere the receiver, and the LED display the state of the power supply at real time.

²  LED display the state of the electric voltage at real time, and LED can display in two colors.

²  The section board’s working states four leads display at real time.

²  The servo supplies power, at the same time diode directly connects with the battery. The voltage drop is approximately 0.3V.

²  Receiver supplies power:

n  Direct connection: When section board uses 5V-6V to supply power, then you can choose “direct connection”.

n  Voltage drop 0.5V:  When section board uses 6V and you don’t like the receive power too height, then you can choose “voltage drop 0.5V”.

n  Voltage drop 7805: When section board uses 7.2V- 8.4V high voltage to supply power, then you can choose “voltage drop 7805”.